2025-01-03

ECU - Charge Port (Remove and Replace)

Correction code 44015002 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Remove

  1. 모든 도어를 열고 창문을 내립니다.
  2. 리프트게이트를 엽니다.
  3. 운전석 시트 및 전면 동승석 시트를 완전히 앞으로 이동합니다.
  4. 12V/LV 전원을 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
  5. 2열 하단 시트 쿠션을 탈거합니다. 참조 항목: Seat Cushion - Lower - 2nd Row (Remove and Replace)
  6. LH 하단 C필러 트림을 탈거합니다. 참조 항목: Trim - C-Pillar - Lower - LH (Remove and Replace) 또는 Trim - C-Pillar - Lower - LH (7 Seat) (Remove and Replace).
  7. 후면 트렁크 적재함 바닥을 탈거합니다. 참조 항목: Trunk Load Floor - Rear (Remove and Replace).
  8. 7인승 차량의 경우: 3열 시트를 접어서 내립니다. 5인승 차량의 경우: 전면 트렁크 적재함 바닥을 탈거합니다. 참조 항목: Trunk Load Floor - Front (Remove and Replace)
  9. 트렁크 실 트림을 탈거합니다. 참조 항목: Trim - Sill - Trunk (Remove and Replace).
  10. LH 트렁크 사이드 트림을 탈거합니다. 참조 항목: Trim - Side - Trunk - LH (Remove and Replace).
  11. 충전 포트 ECU에서 전기 커넥터 3개를 연결 해제합니다.
  12. 충전 포트 ECU를 차체에 고정하는 볼트를 탈거합니다.
    5.5 Nm (4.1 lbs-ft)
  13. 충전 포트 ECU를 밀어 ECU를 차체에 고정하는 탭(2개)을 분리한 다음 차량에서 ECU를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    흰색 인클로저가 장착된 경우 탈거하기 전에 오른쪽으로 밀고, 검은색 인클로저가 설치된 경우 왼쪽으로 밉니다.

Install

Installation procedure is the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
참고
초기 생산 모델의 경우 흰색 인클로저 ECU만 장착할 수 있습니다. 이후 생산된 모델에는 흰색과 검은색 인클로저를 모두 수용할 수 있는 나사산 2개와 슬롯 세트 2개가 있습니다.
  • Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
    Informational PurposesAn informational icon, calling your attention
    참고
    새 ECU를 장착하면 지연으로 인해 12V/LV 배터리가 과도하게 소모될 수 있으므로 소프트웨어 재설치를 즉시 시작하십시오.