Check Strap - Door - Rear - LH (Remove and Replace)
10106552
0.66
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 후면 LH 도어 글라스를 탈거합니다. 참조 항목: Glass - Door - LH - Rear (Remove and Replace).
- LH 후면 창문 모터/조절기 어셈블리를 탈거합니다. 참조 항목: 창문 조절기 - 후면 - LH(탈거 및 교체).
-
LH 후면 도어 체크 스트랩을 차체에 고정하는 볼트를 탈거합니다.
24 Nm (17.7 lbs-ft)TIpUse of the following tool(s) is recommended:- T40 소켓
- 육각 헤드 래칫/플렉스 헤드 토크 렌치
-
LH 후면 도어 체크 스트랩을 도어 어셈블리에 고정하는 너트를 탈거한 다음 도어 어셈블리에서 체크 스트랩을 탈거합니다.
10 Nm (7.4 lbs-ft)TIpUse of the following tool(s) is recommended:- 10mm 딥소켓
- 4인치 익스텐션
Install
Installation procedure is the reverse of removal.