2021-11-11

Shell - Seat Back - Driver (Remove and Replace)

Correction code 13041002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Remove

  1. 운전석 헤드레스트 트림을 시트에서 탈거합니다. Trim - Headrest - Driver (Remove and Replace)을(를) 참조하십시오.
  2. 운전석에 시트 등받이 셸을 고정하는 클립을 분리하고, 셸을 들어 올려 시트 등받이 프레임에서 탈거한 후 셸을 뒤로 눕힙니다.
  3. 시트 하부에 셸 에이프런을 고정하는 클립을 분리한 다음, 시트에서 셸을 탈거합니다.

Install

  1. 운전석 시트 등받이 쉘을 시트 등받이에 배치한 다음 시트 등받이 쉘을 시트 등받이에 고정하는 클립을 조입니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    하단 클립을 먼저 장착한 다음 쉘을 제자리로 돌립니다. 시트 등받이 쉘을 가볍게 눌러 완전히 안착했는지 확인합니다.
  2. 시트 등받이 쉘을 시트 서스펜션에 고정하는 스트랩 클립을 겁니다.
  3. 운전석 헤드레스트 트림을 장착합니다. Trim - Headrest - Driver (Remove and Replace)을(를) 참조하십시오.