2022-04-24

Trunk Assembly - Lower (Remove and Replace)

Correction code 15247002 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

토크 규격

표 1. Torque Specifications: Trunk Assembly - Lower (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
후면 디퓨저를 하단 트렁크 어셈블리에 고정하는 볼트
4 Nm (2.9 lbs-ft)
  • 10mm 딥소켓
Reuse
하단 트렁크 어셈블리를 차량에 고정하는 모서리 볼트
30 Nm (22.1 lbs-ft)
  • 13mm 딥소켓
  • 4인치 익스텐션
Reuse
하단 트렁크 어셈블리를 차량에 고정하는 중간 볼트
10 Nm (7.4 lbs-ft)
  • EP 14 소켓
  • 4인치 익스텐션
Reuse

Remove

  1. 후면 디퓨저를 하단 트렁크 어셈블리에 고정하는 볼트를 탈거합니다.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 딥소켓
  2. 후면 트렁크 카펫을 탈거합니다. Tub - Rear Trunk (Remove and Replace)을(를) 참조하십시오.
  3. 하단 트렁크 어셈블리를 차량에 고정하는 코너 볼트를 탈거합니다.
    30 Nm (22.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 13mm 딥소켓
    • 4인치 익스텐션
  4. 하단 트렁크 어셈블리를 차량에 고정하는 중간 패스너를 탈거합니다.
    10 Nm (7.4 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    패스너의 고무 씰이 손상된 경우 패스너를 교체합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • EP 14 소켓
    • 4인치 익스텐션
  5. 차량에서 하단 트렁크 어셈블리를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    7인승 차량의 경우 위로 똑바로 당겨 시작한 다음 어셈블리를 바깥쪽으로 당기기 전에 어셈블리 후면을 위쪽으로 기울여 3열 시트를 치웁니다.
    그림 1. 7인승

Install

Installation procedure is the reverse of removal, except for the following:

  • 후면 디퓨저를 하단 트렁크 어셈블리에 장착할 때 후면 디퓨저 볼트에 Loctite 222를 도포합니다.