Check Base - Magnetic - Sun Visor - LH (Remove and Replace)
Correction code
15051072
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 모든 도어를 열고 모든 창문을 완전히 내립니다.
- LH 계기판 엔드캡을 탈거합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
- LH 중간 A필러 트림을 탈거합니다. Trim - A-Pillar - Middle - LH (Remove and Replace)을(를) 참조하십시오.
- LH 상단 A필러 트림을 탈거합니다. Trim - A-Pillar - Upper - LH (Remove and Replace)을(를) 참조하십시오.
- LH 선바이저를 탈거합니다. Sun Visor - LH (Remove and Replace)을(를) 참조하십시오.
- 하부 쿼드 카메라 커버를 탈거합니다. Quad Camera Cover - Lower (Remove and Replace)을(를) 참조하십시오.
- 리어 뷰 미러를 탈거합니다. Mirror - Rear View (Remove and Replace)을(를) 참조하십시오.
- 차량의 RH 쪽에 대해 2단계~5단계를 반복합니다.
-
전면 헤드라이너의 앞쪽 가장자리를 고정하는 클립(5개)을 분리합니다.
- 체크 베이스에서 선바이저를 분리합니다.
-
전면 헤드라이너에 선바이저 체크를 고정하는 클립을 분리한 후, 차량에서 선바이저 체크를 탈거합니다.
참고선바이저 체크에서 당기는 동안 클립을 안쪽으로 밀어 선바이저 체크를 분리합니다.
Install
Installation procedure is the reverse of removal.