2020-12-16

Bracket - Harness - Sill Panel - Front - LH (Remove and Replace)

Correction code 15180152 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 하부 A필러 트림을 탈거합니다. Trim - A-Pillar - Lower - LH (Remove and Replace)을(를) 참조하십시오.
  2. 차량의 차체에서 전면 도어 실의 하단을 분리합니다.
  3. 클립 프라이툴을 사용하여 전면 시트 하네스를 전면 실 패널 하네스 브래킷에 고정하는 클립을 분리합니다.
  4. 전면 실 패널 하네스 브래킷을 차량의 차체에 고정하는 클립을 분리합니다.

Install

Installation procedure is the reverse of removal, except for the following:

Informational PurposesAn informational icon, calling your attention
참고
하단 A필러 트림을 장착한 후 전면 도어 실이 완전히 장착되었는지 확인합니다.