2020-12-16

Switch - Light - Center Console (Remove and Replace)

Correction code 15190602 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 모든 도어를 열고 모든 창문을 완전히 내립니다.
  2. 센터콘솔 하단 후면 패널을 탈거합니다. Panel - Lower Rear - Center Console (Remove and Replace)을(를) 참조하십시오.
  3. 센터콘솔 후면 공기 통풍구 어셈블리를 탈거합니다. Assembly - Rear Vent - Center Console (Remove and Replace)을(를) 참조하십시오.
  4. 센터콘솔 엔드 패널을 탈거합니다. End Panel - Center Console (Remove and Replace)을(를) 참조하십시오.
  5. 센터콘솔 후면에서 전기 커넥터를 연결 해제합니다.
  6. 센터콘솔 조명 스위치를 센터 콘솔에 고정하는 나사를 탈거한 다음 스위치를 탈거합니다.
    0.5 Nm (4 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T15 소켓
    • 육각 헤드 래칫/플렉스 헤드 토크 렌치

Install

Installation procedure is the reverse of removal.