2025-02-17

Ball Stud - Liftgate - LH (Remove and Replace)

Correction code 11335032 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 리프트게이트를 엽니다.
  2. 텔레스코픽 스탠드를 사용하여 리프트게이트를 지지합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    스탠드와 리프트게이트 사이에 수건을 놓아 리프트게이트 트림 손상을 방지합니다.
  3. LH 상단 파워 스트럿 클립을 푼 볼 스터드에서 LH 리프트게이트 파워 스트럿을 분리한 다음 파워 스트럿을 한쪽으로 치워 둡니다.
  4. LH 리프트게이트 볼 스터드를 차량에 고정하는 볼트(2개)를 탈거한 다음 차량에서 볼 스터드를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 소켓

Install

  1. LH 리프트게이트 볼 스터드를 차량에 배치한 다음 볼 스터드를 차량에 고정하는 볼트(2개)를 장착합니다.
    11 Nm (8.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 소켓
  2. LH 상단 파워 스트럿 클립을 장착한 다음 파워 스트럿을 한쪽에 장착합니다.
  3. 리프트게이트 지지대를 탈거합니다.
  4. 리프트게이트를 닫습니다.