2021-03-03

Bolster - Seat Cushion - 3rd Row - LH (Remove and Replace)

Correction code 13060012 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 모든 도어를 열고 모든 창문을 완전히 내립니다.
  2. 전면 좌석을 완전히 앞으로 이동합니다.
  3. 2열 시트를 이지 엔트리 모드로 이동합니다.
  4. 3열 시트 쿠션을 탈거합니다. Cushion - Seat - 3rd Row (Remove and Replace)을(를) 참조하십시오.
  5. 3열 LH 시트 쿠션 볼스터를 차량에 고정하는 볼트를 탈거한 다음 볼스터를 앞으로 밀어 어셈블리에서 탈거합니다.
    37 Nm (27.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 13mm 소켓
    • 육각 헤드 래칫/플렉스 헤드 토크 렌치

Install

  1. 3열 LH 시트 쿠션 볼스터를 차량에 배치한 다음 볼트를 장착합니다.
    37 Nm (27.3 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 13mm 소켓
    • 육각 헤드 래칫/플렉스 헤드 토크 렌치
  2. 3열 시트 쿠션을 장착합니다. Cushion - Seat - 3rd Row (Remove and Replace)을(를) 참조하십시오.
  3. 2열 시트 및 전면 시트를 원래 위치로 이동합니다.
  4. 모든 창문을 올리고 모든 도어를 닫습니다.