2025-06-27

Cover - Rear Suspension - LH (Remove and Replace)

Correction code 31032012 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  • 2023-06-15: 보충 목적 전용으로 전체 절차 비디오를 개요로 추가했습니다.

Torque Specifications

표 1. 토크 규격: Cover - Rear Suspension - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
후면 서스펜션 커버를 하단 후면 컨트롤 암 어셈블리에 고정하는 볼트
6 Nm (4.4 lbs-ft)
  • 10mm 소켓
  • 2인치 익스텐션
Reuse

Remove

  1. 차량을 올려서 지탱합니다. 참조 항목: Raise Vehicle - 2 Post Lift.
  2. 후면 서스펜션 커버를 LH 하단 후면 컨트롤 암 어셈블리에 고정하는 볼트를 탈거합니다.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 2인치 익스텐션
  3. 후면 서스펜션 커버를 LH 하단 후면 컨트롤 암 어셈블리에 고정하는 탭(2개)을 푼 다음 차량에서 후면 서스펜션 커버를 탈거합니다.

Install

Installation procedure is the reverse of removal.