Clevis Pin - Brake (Remove and Replace)
Correction code
33253102
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- LH 전면 도어를 열고 LH 전면 창문을 내립니다.
- HEPA 필터 어셈블리를 탈거합니다. 참조 항목: Assembly - Filter - HEPA (Remove and Replace).
- LH 전면 시트를 뒤쪽으로 이동합니다.
- 12V 전원을 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
- 브레이크등 스위치를 탈거합니다. 참조 항목: Switch - Brake Light (Remove and Replace).
-
브레이크 클레비스 핀 코터 핀을 탈거합니다.
-
브레이크 페달 어셈블리에서 클레비스 핀을 탈거합니다.
Install
-
브레이크 페달을 iBooster 로드와 정렬하고 클레비스 핀을 브레이크 페달 어셈블리에 장착합니다.
-
브레이크 클레비스 핀 코터 핀을 장착합니다.
- 브레이크등 스위치를 장착합니다. 참조 항목: Switch - Brake Light (Remove and Replace).
- 12V 전원을 연결합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
- HEPA 필터 어셈블리를 장착합니다. 참조 항목: Assembly - Filter - HEPA (Remove and Replace).
- LH 전면 시트를 원래 위치로 이동합니다.
- LH 전면 창문을 올리고 LH 전면 도어를 닫습니다.