2026-01-08

Stone Guard (Remove and Replace)

교정 코드 18200332 FRT 1.14 메모: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간을 참조하십시오. FRT 값에 대한 피드백을 제공하려면 ServiceManualFeedback@tesla.com으로 이메일을 보내십시오. 메모: 아래 절차를 수행할 때 개인 보호을(를) 참조하여 적절한 PPE를 착용했는지 확인하십시오. 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

  • 2025-12-29: Released new procedure.

탈거

  1. Remove the cooling fan module assembly. See 모듈 - 냉각 팬(탈거 및 장착).
  2. Release the locking tabs (x14) that attach the active grille shutter to the cooling fan and shroud assembly, and then remove the active grille shutter.
  3. Release the locking tabs (x4) that attach the radiator to the fan and shroud assembly, and then slide the radiator out of the holding mounts.
  4. Release the clips that attach the stone guard to the radiator, and then slide the stone guard out to remove it from the radiator.

장착

  1. Align the tabs of the stone guard with the guide datums, and then install the clips that attach the stone guard to the radiator.
  2. Install the locking tabs (x4) that attach the radiator to the fan and shroud assembly.
  3. Install the active grille shutter onto the cooling fan and shroud assembly, and then fasten the locking tabs that attach the shutter to the assembly.
  4. Install the cooling fan module assembly. See 모듈 - 냉각 팬(탈거 및 장착).
  5. Perform a cooling system vacuum refill. See 냉각 시스템(진공 보충).
  6. Install the underhood storage unit. See 후드 내 보관 유닛(탈거 및 교체).