2021-11-11

Cover - Shock Tower - LH (Remove and Replace)

Correction code 12251012 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Cover - Shock Tower - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
후드 내 보관 유닛을 워셔액 저장 탱크 주입구에 고정하는 볼트
5 Nm (3.7 lbs-ft)
  • 10mm 소켓
  • 육각 헤드 래칫/플렉스 헤드 토크 렌치
Reuse

Remove

  1. LH 전면 도어를 열고 LH 전면 창문을 완전히 내립니다.
  2. 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  3. 후드 내 보관 유닛을 워셔액 저장 탱크 주입구에 고정하는 볼트을 탈거합니다.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 육각 헤드 래칫/플렉스 헤드 토크 렌치
  4. 워셔 호스를 워셔 탱크 주입구에 고정하는 탭을 분리한 후, 차량에서 워셔 탱크 주입구를 탈거합니다.
  5. 하네스를 LH 쇼크 타워 커버에 부착하는 클립을 분리합니다.
  6. 좌측 쇼크 타워 커버를 차량에 고정하는 클립을 분리한 후, 커버를 차량에서 탈거합니다.

    LH 쇼크 타워 커버를 표시하였으며 RH도 유사함

Install

Installation procedure is the reverse of removal.