2021-11-11

Sensor - Position - Track - 1st Row Seat - RH (Remove and Replace)

Correction code 13012602 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Remove

  1. RH 전면 도어를 엽니다.
  2. 동승석 좌석을 가장 뒤쪽 위치로 이동합니다.
  3. 시트 트랙 위치 센서 전기 커넥터를 연결 해제합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    센서는 RH 전면 시트의 안쪽 트랙의 바깥쪽에 트랙 모터 뒤쪽에 있습니다.
  4. 시트 트랙 위치 센서를 시트 트랙 어셈블리에 고정하는 나사를 탈거합니다.
    2 Nm (1.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 소켓

Install

Installation procedure is the reverse of removal.