2020-12-16

Lumbar Bun - 2nd Row - Center/20 (Remove and Replace)

Correction code 13059502 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Lumbar Bun - 2nd Row - Center/20 (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
2열 중앙/20 럼버 번을 2열 시트에 고정하는 나사
1.5 Nm (1.1 lbs-ft)
  • Torx T20 소켓
Reuse

Remove

  1. 2열 중앙/20 시트 등받이 패널을 탈거합니다. Remove을(를) 참조하십시오.
  2. 2열 중앙/20 럼버번을 2열 시트에 고정하는 나사를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • Torx T20 소켓
  3. 중앙/20 시트 등받이를 수직으로 세웁니다.
  4. 시트번을 시트 어셈블리에 고정하는 클립(2개)을 분리한 다음 차량에서 시트번을 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    볼스터를 동시에 바깥쪽으로 당겨 탈거를 용이하게 합니다.

Install

  1. 시트 어셈블리에 시트번을 장착하고 클립이 완전히 고정되었는지 확인합니다.
  2. 중앙/20 시트 등받이를 아래로 접습니다.
  3. 2열 중앙/20 럼버번을 2열 시트에 고정하는 나사를 장착합니다.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • Torx T20 소켓
  4. 2열 중앙/20 시트 등받이 패널을 장착합니다. Install을(를) 참조하십시오.