2023-03-21

Window Regulator Motor - Front - LH (Remove and Replace)

Correction code 11505102 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The side impact airbag deployment depends on the front door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the front door shells. Additionally, always reinstall plugs or tape when servicing or inspecting the front doors and their components.

Torque Specifications

Remove

  1. LH 전면 도어 트림 패널을 탈거합니다. Panel - Door Trim - Front - LH (Remove and Install)을(를) 참조하십시오.
  2. 커넥터 잠금 장치를 분리한 후, LH 전면 창문 레귤레이터 모터 커넥터를 연결 해제합니다.
  3. 창문 모터를 클로즈아웃 패널에 고정하는 나사를 탈거한 다음 패널에서 모터를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 소켓
    • 2인치 익스텐션

Install

  1. 클로즈아웃 패널에 창문 모터를 배치한 후, 창문 모터를 클로즈아웃 패널에 고정하는 나사를 장착합니다.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 소켓
    • 2인치 익스텐션
  2. LH 창문 모터 전기 커넥터를 연결한 다음 커넥터 잠금 장치를 체결합니다.
  3. LH 전면 도어 트림 패널을 장착합니다. Panel - Door Trim - Front - LH (Remove and Install)을(를) 참조하십시오.
  4. LH 전면 창문 조절기를 재보정합니다. Window Regulator (Recalibrate)을(를) 참조하십시오.