2024-08-27

OBD 커넥터(새로 장착)

Correction code 00050300 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 필요한 도구:
    • 1115191-00-A - Pick Miniature Soft Grip 90도 팁 6인치
    • 1706381-00-A - 무선 히트 건
    • 1061177-00-C - 키트, 배선 하네스 수리
    • 1944989-00-A - 디피닝 도구 45도

재작업

  1. LV 배터리와 응급구조대 루프를 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
  2. LH 발밑 공간 커버를 탈거합니다. 참조 항목: Cover - Footwell - Driver (Remove and Replace).
  3. OBD 커넥터에서 핀 3(보라색) 와이어 단자를 탈거합니다.
  4. OBD 커넥터에서 핀 11(흰색) 와이어 단자를 탈거합니다.
  5. 핀 3과 11 와이어 단자에 열 수축 튜브를 장착합니다.
  6. 테이프를 붙여 핀 3과 11의 재작업한 와이어 단자를 OBD 와이어 하네스 번들에 고정합니다.
  7. LH 발밑 공간 커버를 장착합니다. 참조 항목: Cover - Footwell - Driver (Remove and Replace).
  8. 연결 해제한 LV 배터리 및 응급구조대 루프를 연결합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).