2020-12-16

SD Card - Car Computer (Remove and Replace)

Correction code 21152402 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. RH 전면 도어를 열고 RH 전면 창문을 완전히 내립니다.
  2. RH 전면 시트를 완전히 뒤로 이동합니다.
  3. 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  4. 12V 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
  5. RH 발밑 공간 어셈블리를 탈거합니다. Cover - Footwell - Passenger (LHD) (Remove and Replace)을(를) 참조하십시오.
  6. 트림 도구를 사용하여 SD 카드 고정 탭을 밀어 올린 다음 플라스틱 핀셋을 사용하여 컴퓨터에서 SD 카드를 탈거합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    이 그림에서 SD 카드 왼쪽에 있는 SIM 카드는 탈거하지 마십시오.
  7. SD 카드 중앙을 반으로 잘라 파기한 다음 각 조각을 반으로 잘라 4조각으로 만드십시오.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    사용자 데이터를 보호하기 위해 SD 카드를 반드시 파기해야 합니다.

Install

  1. SD 카드를 장착 가이드에 배치합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    장착 가이드 슬라이드가 아래쪽으로 향하는지 확인합니다. SD 카드가 완전히 안착할 때까지 도구 상단부에 왼쪽에서 오른쪽으로 밀어 넣습니다. 장착 도중 SD 카드 접점이 뒤쪽을 향해야 합니다.
  2. SD 카드를 차량에 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    가이드 잠금 탭에서 딸깍 소리가 날 때까지 위쪽으로 밉니다.
  3. 12V 전원을 연결합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
  4. 후면 후드 내 에이프런을 장착합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  5. RH 발밑 공간 어셈블리를 장착합니다. Cover - Footwell - Passenger (LHD) (Remove and Replace)을(를) 참조하십시오.
  6. RH 전면 시트를 원래 위치로 이동합니다.