Closeout Panel - Door - Rear - LH (Remove and Install)
Correction code
11701401
0.72
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| 창문 조절기 어셈블리를 도어에 고정하는 볼트 |
![]() 4 Nm (2.9 lbs-ft) |
|
Reuse | |
| 클로즈아웃 패널 어셈블리를 도어에 고정하는 볼트 |
![]() 8 Nm (5.9 lbs-ft) |
|
Reuse |
Remove
- 후면 LH 도어 글라스를 탈거합니다. 참조 항목: Glass - Door - LH - Rear (Remove and Replace).
- LV 배터리 전원을 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
-
커넥터 잠금 장치를 분리한 후, LH 후면 창문 조절기 모터 커넥터를 연결 해제합니다.
-
창문 레귤레이터 패널에서 수동 래치 릴리스 케이블을 탈거합니다.
-
커넥터 잠금 장치를 분리하고 LH 후면 도어 압력 센서 커넥터에서 전기 하네스를 연결 해제한 다음 LH 후면 창문 모터/조절기 어셈블리에서 압력 센서를 탈거합니다.
-
도어 하네스를 클로즈아웃 패널에 고정하는 클립을 분리합니다.
-
창문 조절기 어셈블리를 도어에 고정하는 볼트를 탈거합니다.
4 Nm (2.9 lbs-ft)TIpUse of the following tool(s) is recommended:- 8mm 소켓
- 2인치 익스텐션
-
조절기 레일 패스너를 덮는 플러그를 탈거합니다.
-
클로즈아웃 패널 어셈블리를 도어에 고정하는 볼트를 탈거한 후, 어셈블리를 아래쪽과 바깥쪽으로 밀어 도어에서 탈거합니다.
8 Nm (5.9 lbs-ft)TIpUse of the following tool(s) is recommended:- 10mm 소켓
Install
Installation procedure is the reverse of removal.