2024-02-04

Door Mirror Assembly - LH (Remove and Install)

Correction code 12091101 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2024-01-26: 오류가 있는 첫 번째 단계를 수정했습니다.

Torque Specifications

표 1. Torque Specifications: Mirror - Door - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
LH 도어 미러를 도어에 고정하는 볼트
15 Nm (11.1 lbs-ft)
  • 10mm 소켓
  • 4인치 익스텐션
Reuse
Informational PurposesAn informational icon, calling your attention
참고
최신 버전의 외장 도어 미러의 경우 미러 액추에이터의 빠른 마모 진행 방지를 위해 펌웨어 버전이 2025.2.3 이상이어야 합니다.

Remove

  1. LH 전면 도어 패널을 탈거합니다. 참조 항목: Panel - Door Trim - Front - LH (Remove and Install).
  2. LH 도어 미러 전기 커넥터를 연결 해제합니다.
  3. 창문 전기 하네스를 도어에 고정하는 클립을 풉니다.
  4. LH 도어 글라스 런 씰을 도어에 고정하는 클립을 분리한 다음 도어에서 씰을 제거합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    글라스 런 클립 손상을 방지하려면 트림 탈거 공구를 사용하여 클립을 한 번에 하나씩 부드럽게 들어 올립니다.
  5. 볼트 캡을 탈거한 다음 LH 도어 미러를 도어에 고정하는 볼트(3개)를 탈거합니다.
    15 Nm (11.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    참고

    Use only hand tools to remove or install the fasteners. Do not use impact or power tools.

    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 4인치 익스텐션
  6. LH 도어 미러 어셈블리를 위로 들어 올려 도어에서 분리합니다.
  7. 도어를 통해 그로밋을 누른 다음 미러 어셈블리를 탈거할 때처럼 도어를 통해 전기 하네스를 배치합니다.

Install

Installation procedure is the reverse of removal.