2021-03-22

USB Hub - Seat - 3rd Row (Remove and Replace)

Correction code 13060042 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 3열 시트 쿠션을 탈거합니다. Cushion - Seat - 3rd Row (Remove and Replace)을(를) 참조하십시오.
  2. 3열 시트 컵 홀더 클로즈아웃을 탈거합니다. Closeout - Cup Holder - Seat - 3rd Row (Remove and Replace)을(를) 참조하십시오.
  3. 3열 USB 허브를 시트 쿠션 어셈블리에 고정하는 볼트를 탈거합니다.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • Torx T20 비트
  4. 3열 USB 허브를 위로 들어 올려 3열 시트 쿠션 어셈블리에서 탈거합니다.
  5. 3열 USB 허브 전기 커넥터를 연결 해제합니다.

Install

  1. 3열 USB 허브 전기 커넥터를 연결합니다.
  2. 3열 USB 허브를 3열 시트 쿠션 어셈블리에 아래로 밀어 넣습니다.
  3. 3열 USB 허브를 시트 쿠션 어셈블리에 고정하는 볼트를 장착합니다.
    1.5 Nm (1.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • Torx T20 비트
  4. 3열 시트 컵 홀더 클로즈아웃을 장착합니다. Closeout - Cup Holder - Seat - 3rd Row (Remove and Replace)을(를) 참조하십시오.
  5. 3열 시트 쿠션을 장착합니다. Cushion - Seat - 3rd Row (Remove and Replace)을(를) 참조하십시오.