2023-11-27

Wade Seal - HV Battery (Structural Pack) (Rework)

16103207 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 1080593-00-A 코킹 및 접착제 건
  • 1089956-00-A 접착제, 경화제 제자리 도포, 실리콘, 455g
Informational PurposesAn informational icon, calling your attention
참고
이 절차는 HV 배터리가 차량 외부의 배터리 테이블에 있는 상태에서 수행해야 합니다. 이 절차를 위한 교정 코드를 수리 지시에 별도로 추가해야 합니다.
Informational PurposesAn informational icon, calling your attention
참고
손상 부위가 25mm보다 큰 경우 이 절차를 수행하지 말고 도하 씰을 교체하십시오. 참조 항목: Wade Seal - HV Battery (Structural Pack) (Remove and Replace).
Warning IconA warning icon, calling your attention to a possibly risky situation
경고
이 절차를 수행할 때는 보호 장갑을 착용하십시오.

Procedure

  1. 실리콘 액상 개스킷을 준비합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    개구부 너비가 3mm여야 합니다.
  2. IPA 천을 사용하여 배터리 도하 씰의 해당 부분을 닦아 냅니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    1분 동안 건조시킵니다.
  3. 배터리 도하 씰의 해당 부분에 실리콘 액상 개스킷을 도포합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    코킹 건의 가장 느린 속도 설정을 사용합니다.
  4. IPA를 사용하여 실리콘 액상 개스킷을 고르게 펴 바르고 도하 씰의 나머지 부분은 매끄럽게 폅니다.
  5. 20분 동안 실리콘 액상 개스킷이 마르도록 두십시오.