2021-03-03

Actuator - Recliner - 3rd Row Seat - LH (Remove and Replace)

Correction code 13032802 0.48 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 3열 시트 등받이를 탈거합니다. Seat Backs - 3rd Row (Remove and Replace)을(를) 참조하십시오.
  2. 3열 LH 안쪽 B커버를 시트 프레임 어셈블리에 고정하는 바깥쪽 클립을 탈거합니다.
  3. 3열 LH 리클라이너 액추에이터 케이블을 시트 프레임 어셈블리에서 분리합니다.
  4. 3열 LH 리클라이너 액추에이터 케이블을 시트 프레임 어셈블리의 클립에서 분리합니다.
  5. 3열 LH 리클라이너 액추에이터 전기 커넥터를 연결 해제합니다.
  6. LH 3열 리클라이너 액추에이터를 시트 프레임 어셈블리에 고정하는 볼트를 탈거한 다음 액추에이터를 어셈블리에서 탈거합니다.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 변조 방지 Torx가 있는 육각 비트 세트

Install

  1. LH 3열 리클라이너 액추에이터를 시트 프레임 어셈블리에 배치한 다음 액추에이터를 어셈블리에 고정하는 볼트를 장착합니다.
    2.5 Nm (1.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 변조 방지 Torx가 있는 육각 비트 세트
  2. 3열 LH 리클라이너 액추에이터 전기 커넥터를 연결합니다.
  3. 3열 LH 리클라이너 액추에이터 케이블을 시트 프레임 어셈블리의 클립에 장착합니다.
  4. 3열 LH 리클라이너 액추에이터 케이블을 시트 프레임 어셈블리의 고정 마운트에 장착합니다.
  5. 3열 LH 안쪽 B커버를 시트 프레임 어셈블리에 고정하는 바깥쪽 클립을 장착합니다.
  6. 3열 시트 등받이를 장착합니다. Seat Backs - 3rd Row (Remove and Replace)을(를) 참조하십시오.