2025-09-23

Radar - Cabin (Remove and Replace)

Correction code 17200012 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2025-08-20: 오버헤드 콘솔 커넥터와 헤드라이너 분리에 대한 누락된 이미지를 추가했습니다.

Remove

  1. 전면 도어 및 창문을 엽니다.
  2. LH 및 RH 자석 체크 베이스를 탈거합니다. 참조 항목: Check Base - Magnetic - Sun Visor - LH (Remove and Replace).
  3. 전면 오버헤드 콘솔을 헤드라이너에 고정하는 클립(x2)을 해제한 다음, 헤드라이너에서 콘솔을 내립니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    헤드라이너가 손상되지 않도록 헤드라이너에 대고 비틀지 마십시오. 90도 트림 공구를 돔 라이트 근처에 삽입하고 아래로 당겨 클립을 푼 다음 다른 쪽으로 이동하여 나머지 클립을 풉니다.
  4. 전면 오버헤드 콘솔 커넥터를 연결 해제한 다음, 전면 오버헤드 콘솔을 탈거합니다.
  5. 헤드라이너 전면부를 아래로 당겨서 차체에서 클립(4개)을 풉니다.
  6. 실내 레이더 어셈블리에서 커넥터를 연결 해제합니다.
  7. 실내 레이더를 차체에 고정하는 볼트(토크 9Nm)를 분리하고 클립(1개)을 분리한 다음 차량에서 실내 레이더 어셈블리를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    볼트는 레이더 하우징 내부에 고정되어 있으며 레이더 어셈블리에서 탈거할 수 없습니다.

Install

Installation procedure is the reverse of removal, except for the following: