Seat Back - 2nd Row - RH (Remove and Replace)
Correction code
13054102
0.30
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
- 2024-07-25: 북미 지역 차량용으로 어린이 잠금 장치용 ISOFIX 플래그가 없는 시트 커버는 교체해야 함을 알리는 참고 사항을 추가했습니다.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| RH 등받이 하단 프레임을 차량에 고정하는 볼트 |
![]() 37 Nm (27.3 lbs-ft) |
|
Replace |
경고 볼트를 다음 순서에 따라 장착해야 합니다.
|
Remove
- RH 하단 C필러 트림을 탈거합니다. 참조 항목: Trim - C-Pillar - Lower - LH (Remove and Replace).
-
메인 카펫을 하단 시트 쿠션 프레임에 고정하는 클립을 분리합니다.
-
RH 2열 시트 등받이 프레임을 차량에 고정하는 볼트(4개)를 탈거합니다.
TIpUse of the following tool(s) is recommended:
- 11mm 소켓
- 6인치 익스텐션
- 3/8인치 표준 플렉스 헤드 래칫
- 3/8인치 플렉스 헤드 토크 렌치(장착 전용)
TIp가장 앞쪽에 있는 두 개의 볼트가 메인 카펫 뒤에 있습니다. - 2열 중앙 버클을 탈거합니다. 참조 항목: Buckle - 2nd Row - Center (5 Seat) (Remove and Replace).
-
RH 2열 시트 등받이를 조심스럽게 아래로 접어서 내립니다.
경고시트 등받이 커버에 보호 덮개를 씌우고 시트 등받이 탈거 시 커버가 손상되지 않도록 주의합니다.경고시트 등받이에 추가적인 무게를 가하지 마십시오. 그러는 경우 시트 프레임 정렬 탭이 손상될 수 있으며, 이로 인해 60 및 40 시트 등받이 사이가 균일하지 않게 될 수 있습니다.
-
RH 하단 시트 프레임의 커넥터에서 전기 하네스를 연결 해제합니다.
-
보조 작업자와 함께 RH 2열 시트 등받이 어셈블리를 차량에서 탈거합니다.
경고시트 등받이 어셈블리를 뒤집히거나 손상되지 않는 위치에 놓습니다.참고For NA only: If the 2nd row seat that is not being replaced does not have ISOFIX flag for child locks, replace the seat cover. 참조 항목: Cover - Seat Back - 2nd Row Seat - RH (Remove and Replace).
Install
Installation procedure is the reverse of removal, except for the following:
- 전면 외측
- 후면 내측
- 후면 외측
- 전면 내측
