2024-08-02

Jumper Harness - Trailer Hitch (Remove and Replace)

Correction code 17102012 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2024-07-17: 장착 절차에 추가 이미지를 추가했습니다.
  • 2024-05-16: EU 트레일러 소켓의 부식 방지를 위한 지침을 추가했습니다.

Remove

  1. 후면 페시아를 탈거합니다. 참조 항목: Fascia - Rear (Remove and Install).
  2. 왼쪽 차체 하네스에서 트레일러 히치 점퍼 하네스 전기 커넥터를 연결 해제합니다.
  3. 트레일러 히치 점퍼 하네스를 후면 페시아 브래킷에 고정하는 클립을 풉니다.
  4. 커넥터 잠금 장치를 해제한 다음 트레일러 히치 점퍼 하네스를 히치 어셈블리에서 연결 해제합니다.
  5. 트레일러 히치 점퍼 하네스를 히치 어셈블리에 고정하는 클립을 푼 다음 차량에서 하네스를 탈거합니다.

Install

Installation procedure is the reverse of removal, except for the following:

EU 트레일러 소켓 전용: 물이 유입될 경우 부식 방지를 위해 다음 단계를 수행합니다.

  1. 소켓의 힌지 쪽에서 트레일러 소켓의 가장 낮은 지점에 6mm 배수 구멍을 뚫습니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    소켓 내부의 와이어와 핀이 손상되지 않도록 플라스틱 하우징을 통해 조심스럽게 구멍을 뚫습니다.