2021-05-18

Antenna Amplifier - FM2 (Remove and Replace)

Correction code 21300702 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 리프트게이트 상단 트림을 탈거합니다. Trim - Upper - Liftgate (Remove and Replace)을(를) 참조하십시오.
  2. FM2 안테나 앰프 전기 커넥터를 연결 해제합니다.
  3. FM2 안테나 앰프를 리프트게이트에 고정하는 볼트를 탈거한 다음 어셈블리에서 앰프를 탈거합니다.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 육각 헤드 래칫/플렉스 헤드 토크 렌치

Install

  1. FM2 안테나 앰프를 리프트게이트에 배치한 다음 볼트를 장착합니다.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 육각 헤드 래칫/플렉스 헤드 토크 렌치
  2. FM2 안테나 앰프 전기 커넥터를 연결합니다.
  3. 리프트게이트 상단 트림을 장착합니다. Trim - Upper - Liftgate (Remove and Replace)을(를) 참조하십시오.