2024-09-16

Wheel Arch Liner - Front - LH (Non-Structural Pack) (Remove and Replace)

Correction code 12010902 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2023-06-29: 보충 목적 전용으로 전체 절차 비디오를 개요로 추가했습니다.
  • 1133569-00-A 플라이어, 클립 탈거
Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Remove

  1. LH 전면 휠을 탈거합니다. 참조 항목: Wheel Assembly (Remove and Install).
  2. 전면 에어로 실드 패널을 탈거합니다. 참조 항목: Panel - Aero Shield - Front (Non-Structural Pack) (Remove and Replace).
  3. LH 전면 휠 라이너를 HV 배터리에 고정하는 볼트와 클립을 탈거합니다.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 4인치 익스텐션
  4. LH 전면 펜더 가니시를 탈거합니다. Garnish - Fender - Front - LH (Remove and Replace).
  5. LH 전면 휠 아치 라이너를 차량에 고정하는 클립(14개)을 푼 다음 차량에서 라이너를 탈거합니다.

Install

Installation procedure is the reverse of removal.