2025-09-11

Skid Plate - HV Battery - Front (Remove and Replace)

Correction code 16102002 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2025-07-01: e-코팅이 없는 스키드 플레이트에 대한 토크 규격을 추가했습니다.

Remove

  1. 전면 에어로 실드를 탈거합니다. Panel - Aero Shield - Front (Non-Structural Pack) (Remove and Replace)을(를) 참조하십시오.
  2. LH 및 RH 전면 휠 라이너의 전면을 HV 배터리에 고정하는 클립 및 볼트를 탈거합니다.
    5 Nm (3.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    다음 공구를 사용하는 것이 좋습니다.
    • 10mm 소켓
    • 4인치 익스텐션
    그림 1. LH에서 본 모습, RH도 유사함
  3. 스키드 플레이트를 배터리에 고정하는 볼트 및 클립을 분리한 후, 배터리에서 플레이트를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    스키드 플레이트는 두 가지가 있으며, 각각 패스너 토크 규격이 다릅니다.
    검은색 스키드 플레이트(e-코팅 있음)
    13 Nm (9.6 lbs-ft)
    실버 스키드 플레이트(e-코팅 없음)
    17 Nm (12.5 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    다음 공구를 사용하는 것이 좋습니다.
    • EP10 소켓
    • 4인치 익스텐션

Install

Installation procedure is the reverse of removal.