2024-09-16

Drop Link - Stabilizer Bar - Rear - LH (Remove and Replace)

Correction code 31033402 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  • 2023-06-15: 보충 목적 전용으로 전체 절차 비디오를 개요로 추가했습니다.

Torque Specifications

Remove

  1. 중앙 에어로 실드를 탈거합니다. 참조 항목: Panel - Aero Shield - Rear (Remove and Replace).
  2. LH 드롭 링크를 후면 스태빌라이저 바 및 후면 LH 너클에 고정하는 너트를 탈거하여 폐기합니다.
    55 Nm (40.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    다음 공구 사용을 권장합니다.
    • 5mm 육각
    • 15mm 콤비네이션 플렉스 헤드 렌치
    • 15mm 소켓
    • 육각 헤드 래칫/플렉스 헤드 토크 렌치
  3. 차량에서 드롭 링크를 탈거합니다.

Install

Installation procedure is the reverse of removal, except for the following:

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Replace all nyloc nuts.
  • 너트를 장착한 후 페인트 펜으로 표시하십시오.