18/05/2023 19:55:23

페달 패드 - 브레이크(탈거 및 교체)

교정 코드 33251202 0.12 참고: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오.참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간을 참조하십시오. FRT 값에 대한 피드백을 제공하려면 LaborTimeFeedback@tesla.com으로 이메일을 보내십시오. 참고: 아래 절차를 수행할 때 개인 보호을(를) 참조하여 적절한 PPE를 착용했는지 확인하십시오.

탈거

  1. Open the LH front door and lower the LH front window.
  2. Move the driver front seat rearward.
  3. Release the retaining flaps on the rear of the brake pedal pad, and then peal the pad from the pedal to remove it.

장착

  1. Use IPA wipes to clean the brake pedal, and then position a mirror behind the pedal for installation.
    Informational PurposesAn informational icon, calling your attention
    참고
    Allow 1 minute for the IPA to dry.
  2. Apply a thin layer of P-80 Emulsion temporary rubber assembly lubricant to the mounting grooves on the brake pedal pad, and then insert a wire into the top groove of the brake pedal pad.
    Informational PurposesAn informational icon, calling your attention
    참고
    The wire should be approximately 300mm long and 16-18 AWG. Allow an equal length of wire on each side of the pad. The wire will be used to ease installation.
  3. While pushing down on the center of brake pedal pad, secure the pedal into the three grooves on LH and RH sides and bottom, and then rotate the pad into position.
    Informational PurposesAn informational icon, calling your attention
    참고
    Make sure the LH and RH sides and bottom retaining flaps are fully secure.
  4. While applying pressure to the top of brake pedal pad, pull the ends of the wire forward to engage top retaining flap to brake pedal.
    Informational PurposesAn informational icon, calling your attention
    참고
    Make sure all four retaining flaps are secured to brake pedal.
  5. Move the driver seat to the original position.
  6. Raise the LH front window and close the LH front door.