2022-03-08

Ramp - Airbag - B-Pillar - LH (Remove and Replace)

Correction code 15183702 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. LH 전면 및 후면 도어와 후드 및 리프트게이트를 엽니다.
  2. LH 상단 A필러 트림을 탈거합니다. Trim - A-Pillar - Upper - LH (Remove and Replace)을(를) 참조하십시오.
  3. LH 선바이저를 탈거합니다. Sun Visor - LH (Remove and Replace)을(를) 참조하십시오.
  4. LH 상단 B필러 트림을 탈거합니다. Trim - B-Pillar - Upper - LH (Remove and Replace)을(를) 참조하십시오.
  5. 2열 하단 시트 쿠션을 탈거합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.
  6. LH 후면 도어 씰을 부분적으로 분리한 다음 후면 실 트림 패널 전면부터 시작하여 LH 후면 실 트림 패널을 차량에 고정하는 클립(5개)을 분리합니다.
  7. LH 코트 후크 나사 커버를 연 다음 나사를 탈거합니다(토크 1Nm).
  8. LH 트렁크 사이드 트림을 탈거합니다. Trim - Side - Trunk - LH (Remove and Replace)을(를) 참조하십시오.
  9. LH 상단 C필러 트림을 탈거합니다. Trim - C-Pillar - Upper - LH (Remove and Replace)을(를) 참조하십시오.
  10. 12V 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
  11. 차체에서 헤드라이너의 LH 쪽을 부분적으로 분리한 다음 에어백 램프 테더 스트랩을 테더 브래킷에 고정하는 나사(토크 2Nm)를 탈거합니다.
  12. 차체에서 LH 커튼 에어백을 부분적으로 분리합니다.
    1. 램프 RH 쪽 근처의 볼트(토크 9Nm)를 탈거합니다.
    2. 커큰 에어백을 램프 및 차체에 고정하는 퍼 트리 클립(3개)을 분리합니다.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      경고
      탈거 중 클립이 손상되었다면 커튼 에어백을 교체해야 합니다.
  13. LH B필러 에어백 램프를 차체에 고정하는 볼트(2개)를 탈거합니다(토크 3Nm).

Install

Installation procedure is the reverse of removal.