2023-04-20

Bracket - Trunk Load Floor - LH (Remove and Replace)

Correction code 15305202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 리프트게이트를 엽니다.
  2. LH 후면 동승석 시트 등받이를 분리한 후, 시트 등받이를 아래로 접습니다.
  3. 리어 트렁크 적재함 바닥을 탈거합니다. Trunk Load Floor - Rear (Remove and Replace)을(를) 참조하십시오.
  4. 전면 트렁크 적재함 바닥을 탈거합니다. Trunk Load Floor - Front (Remove and Replace)을(를) 참조하십시오.
  5. 트러크 씰 트림을 탈거합니다. 참조 Trim - Sill - Trunk (Remove and Replace)
  6. LH 적재함 바닥 브래킷에서 위로 당겨 브래킷을 차량에 고정하는 탭(3개) 및 클립(2개)을 분리한 다음 차량에서 브래킷을 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    7인승 브래킷은 클립 2개로 차량에 고정됩니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    밀고 당기기 테스트로 각 장착을 확인합니다. 브래킷을 탈거한 후에는 클립 위치를 조정하지 않아야 합니다. 그렇지 않으면 브래킷이 올바르게 안착하지 않습니다. 클립 위치를 변경했거나 밀고 당기기 테스트 작업에서 브래킷이 고정되지 않은 것으로 보이는 경우 탭에서 클립을 탈거한 다음 클립을 브래킷의 도그하우스에 안착하고 다시 장착합니다.
    그림 1. 5인승
    그림 2. 5인승
    그림 3. 7인승
    그림 4. 5인승

    7인승

Install

Installation procedure is the reverse of removal.