2020-12-16

Fascia - Rear - Lower (Remove and Replace)

Correction code 10012902 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Fascia - Rear - Lower (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
하단 후면 페시아를 상단 후면 페시아에 고정하는 볼트
3 Nm (2.2 lbs-ft)
  • 10mm 소켓
  • 4인치 익스텐션
Reuse

Remove

  1. 후면 페시아를 탈거합니다. Fascia - Rear (Remove and Install)을(를) 참조하십시오.
  2. 하단 후면 페시아를 상단 후면 페시아에 고정하는 볼트(6개)를 탈거합니다.
    3 Nm (2.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 4인치 익스텐션
  3. 하단 후면 페시아 중앙에서 금속 클립을 탈거합니다.
  4. 상단 후면 페시아를 하단 후면 페시아에 고정하는 탭(17개)을 분리한 다음 상단 후면 페시아를 하단 후면 페시아에서 분리합니다.
  5. LH 리플렉터를 하단 후면 페시아에 고정하는 클립과 탭을 분리한 다음 바깥쪽으로 리플렉터를 밀어 페시아에서 탈거합니다. RH 쪽 리플렉터에 대해 이 단계를 반복합니다.
    그림 1. LH 표시; RH 유사함
  6. 견인 후크 커버를 하단 후면 페시아에 고정하는 클립을 분리한 다음 페시아에서 탈거합니다.
  7. 견인 히치 커버를 하단 후면 페시아에 고정하는 클립(15개)을 분리한 다음 커버를 페시아에서 탈거합니다.

Install

Installation procedure is the reverse of removal.