2021-12-26

Bracket - License Plate - Front (EMEA) (Retrofit using Jig)

Correction code 12070126 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 1742127-00-A 전방 LP 지그, 모델 Y, 유럽/중동/아프리카
  • 1742127-IT-A 전방 LP 지그, 모델 Y, IT

Procedure

  1. 전면 번호판 브래킷을 지그에 배치합니다.
  2. 지그를 전면 페시아에 배치합니다. 중앙 표시등(절단 슬릿)을 전면 페시아 그릴의 중앙에 정렬합니다.
    그림 1. 1742127-00-A 을(를) 표시했으며 1742127-IT-A도 유사함
    Informational PurposesAn informational icon, calling your attention
    참고
    전면 페시아 그릴 및 전면 번호판 브래킷과 표면이 고르게 접촉하도록 지그 헤드에 충분한 힘을 가합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    지그 헤드에 손을 올려 지그를 고정하는지 확인하십시오.
  3. 전면 페시아에 전면 번호판 브래킷을 고정하는 자동 태핑 나사(부품 번호 1104972-00-A)(2개)를 장착합니다.
    3 Nm (2.2 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    전면 페시아 손상을 방지하기 위해 나사를 과도한 토크로 조이지 마십시오.
    그림 2. 1742127-00-A 을(를) 표시했으며 1742127-IT-A도 유사함
  4. 전면 페시아 그릴과 번호판 브래킷에서 지그를 밀어내어 제거합니다.