2020-03-26

Thermistor - Duct - Lower - RH (Remove and Replace)

Correction code 18104202 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. RH 센터콘솔 사이드 패널 카펫을 탈거합니다. Side Panel - Center Console - LH (Remove and Replace)을(를) 참조하십시오.
  2. RH 하단 덕트 서미스터를 HVAC 어셈블리에 고정하는 클립을 분리한 다음 HVAC 어셈블리에서 RH 하단 덕트 서미스터를 부분적으로 분리합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    전기 커넥터를 연결 해제할 수 있도록 RH 하단 덕트 서미스터를 부분적으로 분리합니다.
  3. RH 하단 덕트 서미스터 전기 커넥터를 연결 해제합니다.
  4. HVAC 어셈블리에서 RH 하단 덕트 서미스터를 탈거합니다.

Install

  1. RH 하단 덕트 서미스터를 HVAC 어셈블리에 부분적으로 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    전기 커넥터를 연결할 수 있도록 RH 하단 덕트 서미스터를 부분적으로 장착합니다.
  2. RH 하단 덕트 서미스터 전기 커넥터를 연결합니다.
  3. 고정 클립이 완전히 고정될 때까지 RH 하단 덕트 서미스터를 HVAC 어셈블리에 밀어 넣습니다.
  4. RH 센터콘솔 사이드 패널 카펫을 장착합니다. Side Panel - Center Console - LH (Remove and Replace)을(를) 참조하십시오.