2024-11-22

Seal - Liftgate - Side - LH (Remove and Replace)

Correction code 11709202 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 리프트게이트를 엽니다.
  2. 리프트게이트에서 LH 쪽 리프트게이트 씰을 탈거하여 폐기합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    씰은 재사용할 수 없으므로 폐기합니다.
  3. 남은 접착제를 제거하고 IPA 천으로 표면을 닦아냅니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    1분 동안 건조시킵니다.

Install

  1. 마스킹 테이프를 사용하여 LH 쪽 리프트게이트 씰을 임시로 맞춥니다.
  2. 차량이 프리몬트, 오스틴 또는 베를린에서 제조된 경우 마커를 사용하여 씰의 돌출된 끝에 선을 그린 다음, 가위를 사용하여 씰을 올바른 길이로 절단합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    중국에서 제조된 차량은 추가 개조가 필요하지 않습니다.
  3. 접착제 뒷면을 제거한 다음 LH 쪽 리프트게이트 씰을 리프트게이트에 장착합니다.
  4. 리프트게이트에 남아 있는 마스킹 테이프를 떼어냅니다.
  5. 리프트게이트를 닫습니다.