2025-03-21

Connector - Pedestrian Warning Speaker (CN) (Remove and Replace)

Correction code 171007520.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. RH 전면 휠을 탈거합니다. 참조 항목: Wheel Assembly (Remove and Install).
  2. RH 전면 펜더 가니시를 탈거합니다. 참조 항목: Garnish - Fender - Front - LH (Remove and Replace).
  3. 차량에 RH 전면 휠 아치 라이너의 전면부를 고정하는 클립(8개)을 탈거한 다음 휠 아치 라이너를 한쪽으로 치워두고 다음 단계를 수행합니다.
  4. 전기 하네스를 보행자 경고 스피커 어셈블리에 고정하는 클립을 풉니다.
  5. 보행자 경고 스피커 커넥터를 연결 해제합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    커넥터 접근 방식은 차량에 장착된 슈퍼혼 오디오 스피커 버전에 따라 다를 수 있습니다.
  6. 커넥터 잠금 커버를 탈거한 다음 핀(2개)을 누른 상태에서 하네스를 아래로 당겨 차량에서 커넥터를 탈거합니다.

Install

  1. 핀(2개)을 커넥터에 삽입한 다음, 커넥터 잠금 커버를 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    밀고 당기기 검사를 수행하여 핀이 완전히 안착되었는지 확인합니다.
  2. 보행자 경고 스피커 커넥터를 연결합니다.
  3. 전기 하네스를 보행자 경고 스피커 어셈블리에 고정하는 클립을 장착합니다.
  4. RH 전면 휠 아치 라이너의 앞 부분을 차량에 고정하는 클립(8개)를 장착합니다.
  5. RH 전면 펜더 가니시를 장착합니다. 참조 항목: Garnish - Fender - Front - LH (Remove and Replace).
  6. RH 전면 휠을 장착합니다. 참조 항목: Wheel Assembly (Remove and Install).