2024-09-09

Garnish - Fender - Rear - LH (Remove and Replace)

Correction code 12201402 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  • 2023-06-15: 보충 목적 전용으로 전체 절차 비디오를 개요로 추가했습니다.

Remove

  1. LH 후면 펜더 가니시를 차량에 고정하는 클립(12개)을 분리한 다음 차량에서 가니시를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    LH 후면 펜더 가니시 가운데에서 시작하여 차량에서 가니시를 주의하여 당긴 다음 바깥쪽으로 작업합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    가니시 후면을 후면 페시아에 고정하는 탭이 구부러지지 않도록 주의하십시오.

Install

Installation procedure is the reverse of removal, except for the following:

  • 클립을 장착하기 전에 후면 펜더 가니시 정렬 탭을 로커 패널 및 후면 디퓨저에 배치합니다.
  • 후면 펜더 가니시 정렬 탭을 장착했다면 펜더 가니시의 각 끝단에 클립을 장착하고 가운데를 향해 작업합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    가니시 후면을 후면 페시아에 고정하는 탭이 구부러지지 않도록 주의하십시오.