Ground Strap - Rear Drive Unit (Remove and Replace)
Correction code 40012202 1.68 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
- 2024-01-12: 접지 스트랩을 RDU에 고정하는 볼트의 토크 수치를 6Nm에서 10Nm로 업데이트했습니다.
- 2023-06-15: 보충 목적 전용으로 전체 절차 비디오를 개요로 추가했습니다.
Remove
- 차량에서 후면 서브프레임 어셈블리를 탈거합니다. 참조 항목: Subframe Assembly - Rear (Remove and Install).
-
후륜 구동 장치 접지 스트랩을 서브프레임에 고정하는 클립을 풉니다.
-
후륜 구동 장치 접지 스트랩을 후륜 구동 장치 어셈블리에 고정하는 볼트를 탈거합니다.
TIp다음 공구 사용을 권장합니다.
- 10mm 소켓
- 4인치 익스텐션
Install
-
후륜 구동 장치 접지 스트랩을 후륜 구동 장치 어셈블리에 고정하는 볼트를 장착합니다.
10 Nm (7.4 lbs-ft)TIp다음 공구 사용을 권장합니다.- 10mm 소켓
- 4인치 익스텐션
-
후륜 구동 장치 접지 스트랩을 서브프레임에 고정하는 클립을 장착합니다.
- 후면 서브프레임 어셈블리를 장착합니다. 참조 항목: Subframe Assembly - Rear (Remove and Install).