2021-04-22

Switch - Window - Rear (Remove and Replace)

Correction code 11503002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. LH 후면 도어를 열고 LH 후면 창문을 완전히 내립니다.
  2. 나사 커버를 LH 후면 도어 암레스트 가운데에 고정하는 클립을 분리한 다음 암레스트에서 나사 커버를 탈거합니다.
  3. LH 후면 도어 암레스트 가운데의 나사를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 소켓
    • ¼인치 표준 래칫
    • 2인치 익스텐션
    • ¼인치 토크 렌치(장착 전용)
  4. LH 후면 창문 스위치를 도어 트림에 고정하는 탭을 분리하고 트림에서 스위치를 분리합니다.
  5. LH 후면 창문 스위치 전기 커넥터를 연결 해제한 다음 차량에서 스위치를 탈거합니다.

Install

  1. 새 LH 후면 창문 스위치에서 하네스를 분리합니다.
  2. LH 후면 창문 스위치 전기 커넥터를 연결합니다.
  3. LH 후면 창문 스위치를 도어 트림에 장착합니다.
  4. LH 후면 도어 암레스트 가운데에 나사를 장착합니다.
    6 Nm (4.4 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T30 소켓
    • ¼인치 표준 래칫
    • 2인치 익스텐션
    • ¼인치 토크 렌치(장착 전용)
  5. LH 후면 도어 암레스트 가운데에 나사 커버를 장착합니다.
  6. LH 후면 창문을 올리고 LH 후면 도어를 닫습니다.