2023-10-27

Duct - HEPA (Remove and Replace)

Correction code 18103802 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2023-10-16: HEPA 필터 어셈블리를 장착하는 단계를 추가했습니다.

Torque Specifications

표 1. Torque Specifications: Duct - HEPA (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
HEPA 덕트를 스트럿 타워 브레이스에 고정하는 볼트
4 Nm (2.9 lbs-ft)
  • 10mm 소켓
  • 래칫/토크 렌치
Reuse

Remove

  1. HEPA 필터 어셈블리를 탈거합니다. 참조 항목: Assembly - Filter - HEPA (Remove and Replace).
  2. HEPA 덕트를 스트럿 타워 브레이스에 고정하는 볼트를 탈거한 다음 차량에서 덕트를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 래칫/토크 렌치

Install

  1. HEPA 덕트를 벌크헤드의 스터드(2개)에 배치합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    벌크헤드에 HEPA 덕트를 잘못 장착하면 침수가 발생할 수 있습니다.
  2. HEPA 덕트를 스트럿 타워 브레이스에 배치한 다음 HEPA 덕트를 스트럿 타워 브레이스에 고정하는 볼트를 장착합니다.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓
    • 래칫/토크 렌치
  3. HEPA 필터 어셈블리를 장착합니다. 참조 항목: Assembly - Filter - HEPA (Remove and Replace).