2022-08-31

Antenna - Ground Noise Filter - LH (Remove and Replace)

Correction code 21300012 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 리프트게이트 상단 트림을 탈거합니다. Trim - Upper - Liftgate (Remove and Replace)을(를) 참조하십시오.
  2. 리프트게이트 하단 트림을 탈거합니다. Trim - Liftgate - Lower (Remove and Replace)을(를) 참조하십시오.
  3. 백라이트 글라스에서 LH 그라운드 노이즈 필터 안테나를 연결 해제합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    글라스가 손상되지 않도록 주의하십시오.
  4. 볼트를 탈거하고 LH 그라운드 노이즈 필터 안테나를 차량에 고정하는 클립을 분리한 다음 차량에서 안테나를 탈거합니다.
    4 Nm (2.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx Plus IP30 소켓
    • 4인치 익스텐션

Install

Installation procedure is the reverse of removal.