2025-12-12

LV 유지 장치(연결 및 연결 해제)

교정 코드 17010500 0.05 메모: 절차에서 명시적으로 언급하지 않는 한 위 교정 코드 및 FRT는 연결된 절차를 포함하여 이 절차를 수행하는 데 필요한 모든 작업을 반영합니다. 명시적으로 지시하지 않는 한 교정 코드를 누적하지 마십시오. 참고: FRT와 그 생성 방법에 대한 자세한 내용은 표준 정비 작업시간을 참조하십시오. FRT 값에 대한 피드백을 제공하려면 ServiceManualFeedback@tesla.com으로 이메일을 보내십시오. 메모: 아래 절차를 수행할 때 개인 보호을(를) 참조하여 적절한 PPE를 착용했는지 확인하십시오. 안전하고 건강한 작업 사례는 인체공학적 주의 사항의 내용을 참조하십시오.

  • 2025-12-05: Added a caution to make sure windows are not moved for at least 1 minute before disconnecting the LV maintainer.
  • 2023-10-31: Updated the location to attach the maintainer's negative clamp with new images attached.
Warning IconA warning icon, calling your attention to a possibly risky situation
경고
LV 유지 장치를 연결 해제하기 전에 최소 1분 동안 창문을 움직이지 않도록 하십시오. 연결 해제될 때까지 기다리지 않으면 구성품이 손상될 수 있습니다.

연결

  1. On the touchscreen, select the badge icon in Controls > Software for four seconds, and then type "service" into the dialog box to place the vehicle in service mode.
  2. Release the positive terminal cover.
  3. Secure the LV maintainer positive terminal to the jump post.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    To avoid damaging the vehicle, DO NOT allow the positive cable to make contact with other metal components.
  4. Secure the LV maintainer negative terminal to the bolt located between the brake fluid reservoir and front trunk.
  5. Connect the LV maintainer to a power supply, and then power on.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    Never have a LV maintainer and the LV battery simultaneously connected for any extended period of time.
  6. Lift the green locking tab upward, slide the black connector lock outwards, and then pull up to release the LV battery connector.
    Informational PurposesAn informational icon, calling your attention
    참고
    Keep the FRL connected.

Disconnect

  1. Position the LV battery connector onto the LV battery, push the black connector lock inwards to secure, and then press the green locking tab downward to engage when the connector is fully seated.
  2. Power off the LV maintainer.
  3. Release the negative terminal connection from the vehicle first, and then release the positive terminal.
  4. Secure the positive terminal cover.
  5. Confirm that the LV battery State Of Charge (SOC) is above 73% and Battery State is Charge or Standby.
    Informational PurposesAn informational icon, calling your attention
    참고
    If the LV battery SOC is below 73% confirm that Battery State is Charge and Pack Current is positive, Via Tesla Garage > LV.