2023-08-03

Mount - Front Drive Unit - LH (Remove and Replace)

Correction code 39012600 3.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2023-07-26: 절차를 재구성했습니다.

Remove

  1. 전면 서브프레임 어셈블리를 탈거합니다. Subframe Assembly - Front (Dual Motor) (Remove and Install)을(를) 참조하십시오.
  2. 전륜 구동장치 하네스를 전륜 구동장치 인버터에 고정하는 클립(2개)을 탈거합니다.
  3. 전륜 구동장치 LH 마운트를 전륜 구동장치에 고정하는 볼트(3개)를 탈거합니다.
    35 Nm (25.8 lbs-ft) + 55 degrees
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 래칫/토크 렌치
    • 외부 Torx E14

Install

  1. 전륜 구동장치 LH 마운트를 전륜 구동장치에 고정하는 볼트(3개)를 장착합니다.
    35 Nm (25.8 lbs-ft) + 55 degrees
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 각도 측정 토크 렌치
    • 외부 Torx E14
  2. 전륜 구동장치 하네스를 전륜 구동장치 인버터에 고정하는 클립(2개)을 장착합니다.
  3. 전면 서브프레임 어셈블리를 장착합니다. Subframe Assembly - Front (Dual Motor) (Remove and Install)을(를) 참조하십시오.
  4. Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust correction code as a separate activity to the SV. See 얼라인먼트 요구 사항 - 서스펜션.