03/06/2024 17:00:08

Motor - Brake Caliper - Rear - LH (Remove and Replace)

Code de correction 33052302 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.

  • 2024-05-28: Updated EPB Service Mode reference.

Caractéristiques techniques de couple

Tableau 1. Caractéristiques techniques de couple : Motor - Brake Caliper - Rear - LH (Remove and Replace)
Description Valeur de couple Outils recommandés Réutiliser/remplacer Remarques
Boulon qui fixe le support de faisceau du frein de stationnement électrique (EPB) arrière gauche à l’étrier arrière gauche
5 Nm (3.7 lbs-ft)
  • Douille de 10 mm
Réutiliser
Boulons (x2) qui fixent le moteur de l’étrier de frein arrière gauche à l'étrier de frein.
10.8 Nm (8.0 lbs-ft)
  • Hexagonal de 5 mm
Réutiliser

Retirer

  1. Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
  2. Place the vehicle into EPB Service Mode. See Parking Brake - Caliper - Rear - LH (Release).
  3. Remove the LH rear wheel. See Wheel Assembly (Remove and Install).
  4. Release the locking tab, and then disconnect the LH rear EPB caliper connector.
  5. Remove the bolt that attaches the LH rear EPB harness bracket to the LH rear caliper.
    5 Nm (3.7 lbs-ft)
    Conseil : Nous recommandons l’utilisation des outils suivants :
    • Douille de 10 mm
  6. Remove the bolts (x2) that attach the LH rear brake caliper motor to the vehicle, and then remove the caliper motor from the vehicle.
    10.8 Nm (8.0 lbs-ft)
    Conseil : Nous recommandons l’utilisation des outils suivants :
    • Hexagonal de 5 mm

Installer

  1. Position the LH rear brake caliper motor into the vehicle, and then install the bolts (x2) that attach the caliper motor to the vehicle.
    10.8 Nm (8.0 lbs-ft)
    Conseil : Nous recommandons l’utilisation des outils suivants :
    • Hexagonal de 5 mm
  2. Install the bolt that attaches the LH rear EPB harness bracket to the LH rear caliper.
    5 Nm (3.7 lbs-ft)
    Conseil : Nous recommandons l’utilisation des outils suivants :
    • Douille de 10 mm
  3. Connect the LH rear EPB caliper connector, and then engage the locking tab.
  4. Press and hold the Park button to release EPB Service Mode.
  5. Install the LH rear wheel. See Wheel Assembly (Remove and Install).
  6. Remove the vehicle from the lift. See Raise Vehicle - 2 Post Lift.
  7. Perform a road test to ensure proper brake pedal feel and performance.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Per current FRT (00040100).