2025-03-10

Caisson des basses (retirez et remplacez)

Code de correction 21212002 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.

Retirer

  1. Open the liftgate.
  2. Disconnect 12V power. See Alimentation 12 V/BT (déconnectez et connectez).
  3. Remove the trunk sill trim. See Garniture - seuil - coffre (retirez et remplacez).
  4. Remove the upper trunk garnish. See .
  5. Remove the clip that attaches the RH trunk side trim to the body.
  6. Fold back the RH trunk side trim until the bolt that attaches the subwoofer can be removed..
  7. Disconnect the RH trunk side trim puddle lamp connector.
  8. Disconnect the subwoofer connector (x1).
  9. Disconnect the amplifier connectors (x3).
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    Make sure 12V power is disconnected before disconnecting the electrical connectors. Failure to disconnect 12V power before removal can result in damage.
  10. Release the clips that attach the electrical harness to the subwoofer.
  11. Remove the bolt that attaches the amplifier harness to the body.
  12. Remove the bolt and nuts that attach the subwoofer to the body, and then remove the subwoofer amplifier assembly from the vehicle.
    5.4 Nm (4.0 lbs-ft)
    5.4 Nm (4.0 lbs-ft)
  13. Remove the bolts that attach the amplifier to the subwoofer, and then install the bolts that attach the amplifier to the new subwoofer.
    4.3 Nm (3.2 lbs-ft)

Installer

La procédure d’installation se fait en suivant l’ordre inverse de la procédure de retrait.