03/06/2024 16:55:11

Headliner (without e-Call Button) (EMEA) (Retrofit)

Code de correction 15203106 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so.NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email LaborTimeFeedback@tesla.com. NOTE: See Protection individuelle to make sure wearing proper PPE when performing the below procedure.

  • 2023-10-20: Updated steps to change Gateway configuration using Toolbox 3.
This procedure describes the replacement of the headliner with a physical e-Call button on the FOHC (applied to vehicles built before October 2020) by the new type headliner without the physical e-Call button on the FOHC (TPN 1567614-S1-A and later). After replacing the headliner, the vehicle configuration parameters must be updated to ensure that the e-Call functionality becomes available via the touchscreen.

Installer

  1. Install the headliner. See Headliner (Non-Heat Pump) (Remove and Install).
  2. Connect a laptop with Toolbox 3 to the vehicle. See Toolbox 3 (Connect and Disconnect).
  3. Usie Toolbox 3 to change the configuration value for eCallEnabled to enabled_ui_sos. See Configuration de la passerelle (affichage et modification).
  4. On the touchscreen, touch Controls > Safety and make sure that the SOS shortcut button (1) and the SOS EMERGENCY CALL button (2) are available on the touchscreen.
    Informational PurposesAn informational icon, calling your attention
    Note
    The SOS shortcut button (1) takes the user directly to the Safety and Security tab, the SOS EMERGENCY CALL button (2) makes the actual call when touched.
  5. Using toolbox 3:
    1. Select the Actions tab, and then type "VFOHC" in the search field.
    2. Run the ODIN routine TEST-SELF_VCLEFT_X_VFOHCOverhead Console LIN CommunicationModel3/tasks/TEST-SELF_VCLEFT_X_VFOHCLow Voltage Controllers and allow the routine to complete.
    3. Disconnect the laptop from the vehicle.
  6. Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
  7. Inform the customer why the e-Call functionality has changed after the headliner retrofit and instruct them how to use the touchscreen to make an emergency call.