20/12/2023 17:14:06

Hose Assembly - Rocker Side - Rear Drive Unit - LH (Remove & Replace)

Code de correction 18303702

Removal

  1. Open all doors and lower all windows.
  2. Move both front seats fully forward.
  3. Remove the 2nd row seat cushion, and then lift up and support seat bottom frame. See Cadre – base du siège – coussin de 2e rangée (retrait et remplacement).
  4. Remove the LH and RH underhood aprons. See Tablier sous le capot – côté gauche (Retirer et remplacer).
  5. Remove the rear underhood apron. See Tablier sous le capot - arrière (retrait et remplacement).
  6. Power off the vehicle.
  7. Disconnect the 12V power and first responder loop. See Disconnect 12V Power.
  8. Raise and support the vehicle. See Soulever le véhicule - pont élévateur à 2 poteaux.
  9. Remove the LH front wheel. See Ensemble de roue (retrait et installation).
  10. Remove the nut (torque 4 Nm) and clips (x5) that attach the rear half of the LH front wheel arch liner to the body, and then move the rear half of the arch liner to the front side of the rotor.
  11. Put a coolant catcher underneath the front of the vehicle.
  12. Clamp the coolant hose that is connected to the powertrain coolant pump.
  13. Clamp the coolant hose that is connected to the charger and the rear drive unit.
  14. Release the hose clamp that attaches the front end of the LH rocker side hose assembly.
  15. Release the hose clamp that attaches the rear end of the LH rocker side hose assembly.
    Informational PurposesAn informational icon, calling your attention
    Remarque
    Place absorbent material under the hose assembly to catch any spilled coolant.
  16. Release the grommet for the LH rocker side hose assembly from the body.
  17. Pull the LH rocker side hose assembly to the rear, and then pull it out from the rear LH side of the vehicle.

Install

Installation procedure is the reverse of removal, except for the following: