30/01/2024 05:43:26

Capteur de position - Porte - Poignée extérieure - Avant - Gauche (Retirer et Remplacer)

Code de correction 11456502

Dépose

  1. Retirez l'ensemble de la poignée de porte (voir la procédure).
  2. Retirez et mettez au rebut le joint arrière de la poignée de porte.
  3. Retirez l'axe de la biellette de commande pour permettre à la biellette de commande de se dégager du boîtier.
  4. Positionnez la barre de contrôle et retirez la vis qui fixe le capteur de position à la barre (couple de serrage 1 Nm).
  5. Retirez la vis qui fixe le capteur de position au boîtier (couple de serrage 1,5 Nm).
  6. Détacher le faisceau de câbles et retirer les capteurs de position (x2).
  7. Retirez la vis qui fixe le capteur de position au support (couple de serrage 1 Nm).
  8. Retirez le support.

Installation

La procédure d’installation est l’inverse de la procédure de retrait, à l’exception de ce qui suit :

  1. Positionnez tous les câbles autour du boîtier et fixez-les si nécessaire à l'aide de colliers de serrage. Coupez l’excédent de l'attache-câble.
  2. Install a new back seal on the door handle assembly:
    1. Align the stud towers on the door handle assembly with the holes in the back seal.
    2. Press the back seal firmly to properly set the butyl seal between the back seal and the door handle assembly.
      Conseil : Use a suitable tool to apply pressure along the perimeter of the back seal to make sure proper seating of the butyl seal on the door handle assembly.
    3. Put a push nut on top of each stud. Use a deep 5 mm socket to press the push nut over the stud.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      ATTENTION
      Do not use excessive force to drive the push nut into the stud.
      Informational PurposesAn informational icon, calling your attention
      Remarque
      Make sure that the push nut is firmly set into the stud without a gap between the back seal and the door handle assembly.
    4. Repeat steps a-c on the rest of the studs (total of 4 push nuts/studs per front door handle and 3 push nuts/studs per rear door handle).
    5. Use a cable tie to secure the back seal to the door handle assembly.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      ATTENTION
      To avoid damage to the back seal, do not overtighten the cable tie.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      ATTENTION
      To avoid damage to the door handle electrical harness, make sure proper routing of all wires.
      Front door handle Rear door handle
    6. Remove any excess tie.